Uniden WXI377 Owner's Manual page 12

• The base is not
water resistant. Also
wipe off a dirty or
wet handset before
placing in the base.
• Use only the
supplied AD-0002
AC adapter. Do not
use any other
AC adapter.
• Place the power cord
so that it does not
create a trip hazard or
where it could
become chafed and
create a fire or
electrical hazard.
[ 12 ] G E T T I N G S T A R T E D
C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V jack
and to a standard 120V AC wall outlet.
2) Set the base on a desk or tabletop, and
place the handset in the base unit.
3) Make sure that the charge/in use LED illuminates.
If the LED does not illuminate, check to see that the AC adapter is plugged
in and that the handset is sitting correctly in the base.
• Connect the AC adapter to a continuous power supply.
• Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.
• After activating the handset, charge your handset at least 15-20 hours before
plugging into the phone line.
4) Once the handset battery pack is fully charged,
connect the telephone line cord to the TEL LINE jack and
to a telephone outlet.
If your telephone outlet isn't modular,
contact your telephone company
for assistance.
Route the cord.
Modular
www.uniden.com