Using Your Answering System; Playing Your Messages; Repeating A Message - Uniden WDECT3355 Owner's Manual

• The time stamp will
not be heard until
you have set
the time.
• When the answering
system is full,
FL appears on
the base. You
should delete
some messages
so that the system
can record new
messages. (Refer
to "Deleting a
message" on page
50.)
[ 49 ]

uSing yOur anSWEring SySTEM

The message counter displays the number of messages stored in memory. If the display flashes,
then there are new messages waiting for you. The answering system plays your new messages
first. After you play all your new messages, you can then play your old messages.

Playing your messages

1) When the phone is in standby mode, press
The system announces the number of new and old messages while the message counter
displays only the number of new messages. The time and day that each message was
received is announced after the message is played. The message counter will then display
the number of current stored messages.
2) When all new messages have been played, you hear a confirmation tone and the system
announces "End of messages." The system returns to standby. After you have reviewed
your new messages, you can play your old messages by pressing
Once you have listened to a new message, it then becomes an old message. The old mes-
sages will be played in the order in which they were received.

repeating a message

1) Press play/stop to review your messages. The number of stored messages
is announced.
2) To repeat the current message, press
ning the message. To quickly scroll backwards through a message, press and hold
repeat/SELECT.
To repeat the previous message, press
seconds during remote operation) after a message begins playing. If you have several mes-
sages, press repeat/SELECT repeatedly until you return to the message you want to
replay. If the current message is the first new message, the system plays back from the begin-
ning of the current message (it does not go back into the old message group).
3) Press play/stop at any time to stop reviewing messages and return to standby. The
message counter shows the number of messages stored in memory.
play/stop.
repeat/SELECT after a few seconds of begin-
repeat/SELECT within a few seconds (about 4
play/stop again.