Cisco 5100 Series Hardware Installation Manual page 22

Rack-Mounting the Chassis
• Front mounting—Brackets attached at the front of the chassis with the front panel facing forward
• Back mounting—Brackets attached at the back of the chassis with the back panel facing forward
Attaching Brackets to the Chassis
Attach one mounting bracket to each side of the device as shown in following figures. You need two screws
to attach each bracket to the device. Total four screws are required to attach both brackets to the device. Use
the screws provided with the mounting kit to attach the screws to the device.
Figure 5: Bracket Installation for Front Mounting
Figure 6: Bracket Installation for Back Mounting
Mounting the device in a Rack
After you attach the brackets to the device, install the chassis on the rack as shown in following figures. You
need two screws to attach each bracket to the rack. Total four screws are required to attach the device to the
rack. The screws for attaching the device to the rack are not provided with the kit.
Cisco 5100 Enterprise Network Compute System Hardware Installation Guide
16
Installing the Device