Mount The Base Unit On A Wall - Uniden SS E15 Series Owner's Manual

D. Mount the Base Unit on a Wall
Standard wall plate mounting
This phone can be mounted on any standard
wall plate.
1) Remove the wall mount adapter from the
base and snap it into the notches on the
bottom of the base.
2) Plug the AC adapter to the
3) Wrap the AC adapter cord inside the
molded wiring channel as shown.
4) Plug the AC adapter into a standard
240V AC wall outlet.
5) Plug the telephone line cord into the
line jack.
6) Wrap the cord inside the molded wiring
channel as shown.
7) Plug the telephone line cord into the
telephone outlet.
8) Raise the antenna to a vertical position.
9) Align the mounting slots on the base with the
mounting posts on the wall.
Then push in and down until the phone is firmly seated.
Direct wall mounting
If you don't have a standard wall plate, you can mount your phone directly to the wall.
Before doing this, consider the following:
• Avoid electrical cables, pipes, or other items behind the mounting location that could
cause a hazard when inserting screws into the wall.
DC in 9V jack.
tel
[9]
If the base unit is
mounted on the
wall, always put
the handset in
the base with the
CID display
facing forward to
make sure the
handset does not
fall out of the
base.