Polaris MSX 110 Owner's Manual For Maintenance And Safety page 39

OPERATION
Pre-Operation Inspection
NOTE: Detailed instructions for how to perform the procedures in the inspection chart are contained on the
following pages.
Item
Bilge Drain water from the bilge before
placing the watercraft in the water.
Drain plugs/bilge Inspect; clean; be sure each plug is
tight, secure and doesn't leak.
Fuel/oil levels Check levels of fuel and oil (page 40);
add as needed; inspect for presence
of water.
Coolant Check level, add as needed
(page 80).
Jet pump Inspect and remove any debris; en-
water intake sure intake grate is secure; push rear
of craft up and down in the water to
flush sand out of water intake before
starting.
Throttle Check for proper operation.
Steering Check for proper operation; inspect
control cable.
Fire extinguisher Inspect condition/expiration date.
36
What To Do
https://www.boat-manuals.com/
Item
Battery Check fluid level/condition; vent hose
must be clear and open.
Switches/buttons Check for proper operation.
Lanyard cord/stop Check condition and operation.
switch
Loose parts/hoses Inspect for loose parts/hoses and
connections; tighten as needed.
Hull Inspect hull for damage or cracks;
clean off any marine growth.
Storage Check and secure latches.
compartment
Engine cover (seat) Remove and ventilate engine
compartment before starting
engine. Secure seat latches.
Loose ropes/ Be sure that there are no loose ropes,
straps/clothing/long straps, clothing, etc.;
hair Long hair is tied back and secured.
Riding gear Check operator and passenger for
complete gear and proper fit.
Reverse System Check for proper operation.
What To Do