Uniden EXI3246 Series Owner's Manual page 12

• Use only the
supplied AD-0001
AC adapter.
Do not use any other
AC adapter.
• Place the power cord
so that it does not
create a trip hazard or
where it could
become chafed and
create a fire or
electrical hazard.
[ 12 ] G E T T I N G S T A R T E D
C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V jack
and to a standard 120V AC wall outlet.
2) Set the base on a desk or tabletop, and
place the handset in the base unit.
3) Raise the antenna to a vertical position.
4) Make sure that the charge/in use LED illuminates.
If the LED does not illuminate, check to see that the AC adapter is plugged in
and the handset makes good contact with the base charging contacts.
• Connect the AC adapter to a continuous power supply.
• Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.
• After installing the battery pack in the handset, charge your handset at least 15-20
hours before plugging into the phone line.
5) Once the handset battery pack is fully charged, connect the
telephone line cord to the TEL LINE jack and to a telephone
outlet.
If your telephone outlet isn't modular,
contact your telephone company
for assistance.
Route the cord.
Modular
www.uniden.com