Instructions For Building-In - Miele KM 83-2 Operating Instructions Manual

Installation
• Test the appliance and instruct the
user making sure that the User's
Instructions are left with the User.
If any of the above procedures do not
produce satisfactory results, the
Miele Service Department should be
consulted for more specialised as-
sistance.
• Check burner flames of the ap-
pliances operated at turndown gas
consumption on available gas, if the
associated cupboard doors are op-
ened and closed. If the flame extin-
guishes, any hole in the base has to
be sealed. Repeat test, if necessary.
• Prepare the worktop cut-out as illus-
trated.
Dimension "B" applies for a combina-
tion of appliances and is given on
the chart.
22
Instructions for building-in
Depth
in
mm
2 zone Combiset
1 element
2 elements
3 elements
4 elements
5 elements
490
490
490
490
490
4 zone Combiset
1 elements
2 elements
3 elements
490
490
490
Combination
One 2 zone
+ one 4 zone
Two 2 zone
+ one 4 zone
Three 2 zone
+ one 4 zone
One 2 zone
+ two 4 zone
Two 2 zone
+ two 4 zone
490
490
490
490
490
Width
(=
Dimen-
sion B)
in mm
265
558
851
1144
1437
560
1143
1728
851
1143
1437
1436
1729
Extractor (e.g. DA 8-2)
For building in between two appliances:
- Dimension B increases by 90 mm.
For building in at the end ot a combination:
- Dimension B increases by 98 mm.
Stick the seal provided © under the
edge of the hob.
® Appliance
© Tensioning screw
© Clamp
© Worktop
©Seal
• Turn the tensioning screws © in the
clamps in an anti-clockwise direction
into the appliance © until a resist-
ance is met and turn the clamp to
the left.
• Place the appliance into position,
turn the clamps and tighten the ten-
sioning screws until the clamps
press into the worktop ®.
• Connect the appliance to the elec-
tricity supply.
• Connect the appliance to the gas
supply in accordance with gas sup-
ply regulations.
When building-in several Combiset
units, a spacer bar must be fitted be-
tween each unit. It is supplied with its
own installation instructions.
23