Handset Registration; Handset - Uniden DECT1915+1 User Manual

Handset registration

You don't need to register any handsets which were
!
supplied as part of the system with your base unit —
they are already registered. But if you've bought any
extra handsets separately, you'll need to register them.
To check whether a handset is already registered, make
sure mains power to the base unit is switched on
and the handset is within range. The handset's display
should show its name (default
If the display constantly shows
need to register the handset.
Each handset can be registered to up to four base
units, which have numbers 1 to 4.
To re-register 1 On the base unit, press and hold the
or to register a HANDSET LOCATOR button until you hear
new handset Registration tone (repeated 'beeps')
You now have 60 seconds to register the

handset.

2
On the handset, press the right Soft button
Menu
[ ], then press the
scroll to Handset
3 Press the right Soft button [
‡
4
Press the or
then press the right Soft button [
u The display shows a list of base units. If any
of these numbers has a tick next to it, the
handset is already registered to that base unit.
5
Move the highlight to
right Soft button [
u The display shows
6 Key in the base unit's PIN code (default 0000)
If the base unit's PIN code has been changed
from 0000 (see page 44), you'll need to know
the current PIN code.
28
Handset ) and number.
No base found , you
‡ ˆ
or button to
OK
]
ˆ
Register,
button to scroll to
OK
]
BASE: 1
then press the
OK
]
Base-PIN: