Handset Registration - Uniden DECT1905 User Manual

Handset registration

You must register the DECT 1905 handset to a
!
compatible base (DECT 1915 or DECT1955 series base)
before use.
To check whether a handset is already registered, make
sure mains power to the base unit is switched on
and the handset is within range. The handset's display
should show its name (default
If the display constantly shows
need to register the handset.
Each handset can be registered to up to four base
units, which have numbers 1 to 4.
To re-register 1 On the base unit, press and hold the
find hs
or to register a FIND HS button until you hear
new handset Registration tone (repeated 'beeps')
You now have 60 seconds to register the
handset.
2
On the handset, press the right Soft button
Menu
[ ], then press the
scroll to Handset
3 Press the right Soft button [
‡
4
Press the
then press the right Soft button [
u The display shows a list of base units. If any
of these numbers has a tick next to it, the
handset is already registered to that base unit.
5
Move the highlight to
right Soft button [
u The display shows
6 Key in the base unit's PIN code (default 0000)
If the base unit's PIN code has been changed
from 0000 (see your base unit's User Guide), you'll
need to know the current PIN code.
7
Handset
) and number.
No base found , you
‡ ˆ
or button to
OK
]
ˆ
Register,
or button to scroll to
OK
]
BASE: 1
then press the
OK
]
Base-PIN: