Tone Dialing Switch-Over; Registering A New Handset - Uniden DECT160 Owner's Manual

5 Press or to display either
and press
6 Press to exit and return to standby.

Tone Dialing Switch-Over

If you have set your phone to use Pulse dialing,
you can switch temporarily to Tone dialing for the
duration of a call:
1 Press .
2 Enter the number you want. Press and
hold , will be displayed.
Any digits entered after the
using tone dialing.
or
to confirm.
will be dialed

Registering a new handset

When you register a new handset to your base,
you will be asked to enter the base PIN code.
The pre-set PIN code is 0000. If you wish you can
change this code, see page 29.
Before registering, make sure the new handset is
fully charged and that you have the base and
handset in front of you. Also, make sure all
handsets and the base are in standby.
On the handset you want to register:
1 Press to access the main menu.
2 Press or
displayed and press
3 Press or
press
.
4 Press or
number and press
On your base:
5 Press and hold
You are now in 'registration mode'.
[27]
until
.
to display and
to select your base
.
for approx. 3 seconds.
is