Operation Symbols; Quick Start Label Symbols - Champion 100683 Operator's Manual

100683 - CURvED ShAfT TRiMMER

Operation Symbols

Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of
these symbols will allow you to more safely operate the product.
SYMBOL

Quick Start Label Symbols

Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of
these symbols will allow you to more safely operate the product.
Starting the Engine
1. Check fuel. Make sure fuel-to-oil mixture is 50:1 and add
if necessary.
2. Primer bulb:
2a. For cold starts, press primer bulb 7-10 times.
2b. For warm starts, DO NOT press primer bulb.
Artwork Notes
3. Move choke lever to CHOKE position.
3mm corner radius; 2mm safe margin; to be printed
4. Holding the unit firmly, pull starter handle until the engine
on white substrate.
starts.
This artwork belongs to Champion Power Equipment. The contents are confidential and privileged and shall not be disclosed to or used by or for
outside parties without the explicit consent of Champion Power Equipment.
MEANING
Choke. Move choke lever to "RUN"
position. See Starting and Stopping
Section.
Choke. Move choke lever to "CHOKE"
position. See Starting and Stopping
Section.
1
50 : 1
4
LPN
Rev
Size
2
7-10X
5
5. Press the throttle trigger lockout (top) and throttle trigger
(bottom) when the engine starts. This will automatically
1939-L-OP
move the choke lever to the RUN position. Once the engine
is running, release the throttle lockout and throttle trigger.
A
6. Allow the engine to idle for 30 seconds.
53 x 24 mm
---
8
iMPORTANT SAfETY iNSTRUCTiONS
3
6
30 s
Colors
K K:50 152
Revision Changes
2945 485