Assembly; Operation; Fueling And Refueling - Champion 100683 Operator's Manual

100683 - CURvED ShAfT TRiMMER

ASSEMbLY

Your trimmer requires some assembly. If you have any
questions regarding the assembly of your trimmer, call our
Technical Support Team at 1-877-338-0999. Please have your
serial number and model number available.
1. Attach the trimmer handle by placing both pieces of the
handle around the trimmer shaft at the desired length.
Fasten both pieces together by tightening the bolts
clockwise with the Allen wrench provided.
2. Install the grass shield by placing (2) bolts through the
grass shield assembly and fasten the bolts to the grass
shield clockwise using the Allen wrench provided.
3. Assemble the trimmer head to the unit by placing the
trimmer head into the trimmer assembly. Keep the
assembly from spinning by placing a screwdriver or Allen
wrench in the trimmer head slot. Tighten the trimmer head
onto unit by rotating it clockwise.

OPERATiON

fueling and Refueling

Fuel Mixture
This product is powered by a 2-cycle engine and requires
pre-mixing gasoline and 2-cycle oil in a 50:1 ratio. Pre-mix
unleaded gasoline and 2-cycle engine oil in a clean container
approved for gasoline. DO NOT mix quantities larger than usable
in a 30-day period. Recommended fuel: This engine is certified
to operate on unleaded gasoline intended for automotive use.
When mixing fuel, always use clean, fresh, regular unleaded
gasoline with a minimum octane rating of 87 and an ethanol
content of 10% or less by volume. DO NOT USE E15 or E85.
Recommended oil: Use premium 2-cycle oil, or an equivalent
high-quality synthetic 2-cycle oil. Do not use automotive oil or
2-cycle outboard oil.
Gasoline (US gal.)
1
2.5
3.0
4.0
5.0
Gasoline (L)
3.8
9.5
11.4
15.1
18.9
11
ASSEMbLY
Oil (oz.)
2.6
6.4
7.7
10.2
12.8
Oil (ml)
76
190
228
302
378