Replacing Trimmer Line; Maintenance; General Maintenance - Champion 100683 Operator's Manual

100683 - CURvED ShAfT TRiMMER

Replacing Trimmer Line

1. Place the provided Allen wrench or a screw driver into the
cut out on the trimmer head to prevent the assembly from
moving.
2. Rotate the head counterclockwise to remove the string
head.
3. Remove the string holder.
4. Make sure the replacement line is 0.095" (2.4mm) line.
Fold the replacement string line in half and connect to the
spool. Rotate the string around the spool in the direction
indicated by the arrows on the spool.
5. Lock the string into the opposite detents leaving about 5"
(120mm) on each side.
6. Thread the remaining string through the holes on the string
trimmer head assembly.
7. Assemble the bump head to the unit by rotating clockwise
and adjust the string length as needed.

MAiNTENANCE

General Maintenance

Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use a clean cloth to
remove dirt, dust, lubricant, grease, etc.
Before inspecting, cleaning, or servicing the machine, shut
off engine, wait for all moving parts to stop, and disconnect
spark plug wire and move it away from spark plug. Failure
to follow these instructions could result in personal injury or
property damage.
When servicing, use only identical replacement parts. Use
of any other parts could create a hazard or cause product
damage.
Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact with
plastic parts. Chemicals can damage, weaken, or destroy
plastic which could result in serious personal injury.
Tampering or adjusting the factory set carburetor is a
Federal Violation and will void your warranty coverage.
15
MAiNTENANCE
WARNiNG

WARNiNG

WARNiNG

WARNiNG
