To Stop The Engine - Champion 100683 Operator's Manual

100683 - CURvED ShAfT TRiMMER
4. Holding the unit firmly, pull starter handle until the engine
starts.
5. Press the throttle trigger lockout (top) and throttle trigger
(bottom) when the engine starts. This will automatically
move the choke lever to the RUN position. Once the engine
is running, release the throttle lockout and throttle trigger.

Manually adjusting or turning the choke lever to the CHOKE
position during idle will cause the engine to stop.

Allow engine to warm at least 30 seconds depending on
ambient temperature. The colder the temperature, the longer
the warm up required.
NOTiCE
NOTiCE
To Start a Warm Engine:
1. Do not adjust the CHOKE lever. It should already be in the
RUN position. If not, press the throttle trigger lockout (top)
and throttle trigger (bottom) once. This will automatically
move the choke lever back to the RUN position.
2. Holding the unit firmly, pull starter handle until engine
starts. Use short pulls and do not allow the rope to snap
back.
If the engine does not start, return to the "Start a Cold Engine"
and repeat the steps that follow.

To Stop the Engine:

To stop the engine, depress and hold the throttle switch to the
STOP position.
13
OPERATiON
NOTiCE
