Receiving & Inspecting The Unit - CellarCool OPTIMUM Series Owner's Manual

RECEIVING AND INSPECTING THE UNIT
Upon receiving your CellarCool unit:
• Lift only at the designated hand-hold locations on the shipping container, or fully support the unit from underneath. A
shipment may include one or more boxes containing accessories.
• Inspect the packaging for any obvious signs of damage or mishandling before opening the container.
• Place the box containing the CellarCool unit on a tabletop to prepare it for testing prior to installation.
• Review the packing slip to verify the package's contents.
• Check the model number to ensure it is correct.
• Check that all factory options ordered are listed.
• Check the box for the following:
NOTE: CellarCool units are manufactured in the USA and tested prior to shipment.
Please leave the CellarCool unit in its original box until you are ready for installation. If the unit is to be stored for any length of time
prior to installation, ensure that the unit is stored on a flat level surface in the upright position. This will allow you to move the
product safely without damaging it. When you are ready to remove the product from the box, refer to the installation instructions.
TIP: Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
Page 4
2200 / 3300 / 4400 / 8800
Single-piece mounting bracket
Accessory kit #1:
• (1) CellarCool Optimum Series owner's manual
• (1) Bypass plug
• (1) Liquid-measuring thermostat (bottle probe)
Accessory kit #2:
• (1) Power cord (8 feet)
• (1) Piece of mounting bracket insulation foam (6 feet)
• (11) 1¾" standard screws
• (7) 1/2" Phillips pan-head screws
• (1) Drain line tube (1/2" ID clear plastic tubing, 10 feet)
• (1) 1/4" FNPT x 1/2" Hose elbow
011420
CX