Table of Contents
Advertisement
6
Slide the wiring cover (a) up the extension tube, allowing about a 1/8" (3 mm) gap to the ceiling. Rotate
the wiring cover so that the mounting slots align with the screw holes on the extension tube, and then
secure it with the screws (b). Make sure that there are no wires visible. If there is not enough clearance
between the cover and ceiling, move the screw to the lower hole.
7
Slide the wiring cover trim (c) up the extension tube, aligning the tabs on the inside with the slots on the
bottom of the wiring cover. Twist clockwise to snap into position.
HAIKU
®
BY BIG ASS FANS
INSTALLATION COMPLETED
41
Advertisement
Table of Contents
