Troubleshooting; Audible Feedback - Lowrance Ghost Series Operator's Manual

20 |

Troubleshooting

Problem
Motor not running
Motor loses power after a
short running time
Direction indicator hangs
up or stutters during
rotation
Propeller vibration during
operation
Anchoring or heading
issues
Trolling motor does not
appear as a device in the
display unit
Cannot get the sonar to
work

Audible feedback

Beep pattern Description
Enabling anchor mode
Enabling heading lock mode
Enabling course lock mode
1 short beep
Enabling constant ON mode
Speed increased (from remote controller or multifunction display)
Speed decreased (from remote controller or multifunction display)
Disabling anchor mode
Disabling heading lock mode
2 short beeps
Disabling course lock mode
Disabling constant ON mode
Error, the 3 short beeps will be followed by a specific beep pattern to
3 short beeps
indicate the error. For more information, refer to "Audible error messages"
on page 21.
4 short beeps Trolling motor startup sequence completed
2 long beeps
Calibration initiated
Broadcast Bluetooth pairing
3 long beeps
Calibration completed
Bluetooth pairing completed
Service and Maintenance | Ghost Series Operator Manual
Action
Check battery connections for proper polarity.
Make sure terminals are clean and corrosion free. Use fine
sandpaper or emery cloth to clean terminals.
Check the condition of the battery, refer to the battery
suppliers recommendations.
Check for proper battery voltage.
Check battery charge level.
Check power wires and connections, make sure that the
correct cable diameter is used.
Clean the indicator. Remove the indicator by prying it off
with a flat head screwdriver. Blow/wash out carefully if
necessary.
Inspect the propeller and propeller shaft for damage and
replace if necessary.
Remove and rotate the prop 180°.
Perform calibration of the compass and/or bow offset.
Refer to the Installation Manual.
Check the NMEA 2000 wiring.
Make sure that the proper sources have been selected.
Refer to the documentation supplied with your display unit
for more information.
Check the sonar wiring.
Verify that the sonar is properly set up on the compatible
multifunction display unit.