Adjusting The Braided Stainless Steel Pull Cable Length - Lowrance Ghost Series Operator's Manual

Adjusting the braided stainless steel pull cable length

Tools required
•
2x Small flat headed screwdrivers
•
1x 2 mm hex key
•
1x Side-cutting pliers
Procedure
1
Apply pressure to both sides
2
Loosen the 2 set screws (D) and slide the pull cable (E) to the desired length.
3
Apply thread locker to the 2 set screws (D) if needed. Tighten the set screws and cut the pull
cable (E) approximately 5 mm (1/5") above the clamp (F).
4
Re-install the handle top cover by pushing it down onto the handle.
Adjusting the trolling motor |
and C) of the locking tabs (A) to remove the handle top cover.
(B
B
C
A
A
D
E
D
F
Ghost Series Operator Manual
A
| 11