Caution When Handling; Inspection - NAMCO LUCKY & WILD Manual

2-2 Caution When Handling

AC power must always be turned OFF, and the game unplugged, before
replacing any parts or connecting/disconnecting connectors.
b.
When unplugging the game from an elecaical outlet, always grasp the plug,
not the cord.
Do not subject game to physical shock when transporting or moving it.
C.
d. The power supply range is between 1 IO-120VAC, (switchable to 220 VAC).
The cabinet must be grounded with a securely connected ground plug.
f. Care must be taken at all times to avoid electrical shock whenever inspecting
or adjusting the game, particularly around the monitor.
Always return the levelers to the extreme "up" position before moving the
game, and separate the game into its two assemblies - cabinet and seat.
h. Adjustment is required whenever the game PC board, gun, steering wheel,
pedal assemblies or potentiometers are changed,
i. DO NOT attempt to repair the Printed Circuit Board (PCB). It contains
sensitive chips that could easily be damaged by even the
of a multi-meter. Always return the PCB to your distributor for any repairs.

3. INSPECTION

NOTE: The Control Panel (dashboard) is shipped separately with the Monitor
Cabinet, and must be installed by the operator as described in Section 4-2.
The LUCKY & WILD Game cartons should be carefully inspected upon receipt to
insure that the game is complete and was delivered in good condition.
Inspect the game cabinet by doing the following:
1. Examine the cabinet exterior for dents, chips, or broken parts.
2. Unlock and open the rear service door and the front coin door.
Inspect the interior of the cabinet as follows:
a. Verify that all plug-in connectors (on the cabinet harnesses) are firmly
plugged in. DO NOT force connectors together. The connectors are keyed so
they fit only in the proper orientation. A reversed edge connector can damage
a PCB and will void your warranty.
b. Inspect the power cord to insure that there are no cuts or dents in the insula-
tion.
c. Inspect the power supply connectors.
d. Inspect other major sub-assemblies, such as the video display monitor, PCB,
gun assemblies, steering assembly and speakers. Make sure that they are
mounted securely and that all ground wires are firmly connected.
2
small
internal 'voltage