Balanced Body STUDIO How To Install

How to install the Padded Jumpboard
STUDIO REFORMER®
Standard Footbar
To install the jumpboard
(regular or Jumpus Maximus)
on equipment with a "standard"
footbar design, first loosen
the two black knobs located
beneath the standing platform
at the foot end of the frame.
Place the spring bar into the
second "gear" from the end of
the frame (Figure A).
Drop the shorter of the two footbar supports into the first "gear."
The longer footbar support will rest on top of the standing
platform (Figure A). Gently slide the wooden tongue of the
padded jumpboard into the silver bracket on the inside of the
frame. Finally, tighten the two black knobs on the outside of the
frame to lock the jumpboard into position.
The black, padded portion of
the footbar is intended to be
behind the wooden block on
the back of the jumpboard, not
pulled up on top of it (Figure B).
Infinity Footbar®
To install the jumpboard
(regular or Jumpus Maximus)
on a Reformer with an Infinity
Footbar, first loosen the two
black plastic knobs beneath the
standing platform at the foot
end of the frame.
Adjust the footbar to the
4th position from the end of
the Reformer. Then adjust
the footbar to the second
highest vertical position (Figure C). Next, place the tongue of the
jumpboard into the silver bracket on the inside of the frame.
Finally, re-tighten the black knobs on the outside of the frame.
Figure A
Figure B
Figure C
One-Step Footbar
To install the padded jumpboard (regular or Jumpus Maximus) on
Reformers with the One-Step Footbar, first loosen the two black
knobs located beneath the standing platform at the foot end of
the frame. Place the footbar support into its lowest position. Gently
lower the tongue of the jumpboard into the silver bracket and
tighten the black knobs until snug.
The black, padded portion of the footbar is intended to be behind
the wooden block on the back of the jumpboard, not pulled up
on top of it
REVO® Footbar
To install the padded jumpboard (regular or Jumpus Maximus) on
Reformers with the Revo Footbar, first loosen the two black knobs
located beneath the standing platform at the foot end of the
frame. Place the footbar support into its lowest (bottom) position.
Gently lower the tongue of the jumpboard into the silver bracket
on the inside of the frame.
The black, padded portion of the
footbar is intended to be behind the
wooden block on the back of the
jumpboard, not pulled up on top of
it. Gently tighten the black knobs
until snug (Figure D).
XSR REFORMER
Revo jumpboard and Revo jumpus
maximus jumpboard both work
on the XSR Reformer. To install
the padded jumpboard into the
XSR reformer, first loosen the two
black knobs located beneath the
standing platform at the foot end
of the frame. Place the footbar into
the fourth position from the top
in the trunnion. Gently lower the
tongue of the jumpboard in to the
silver bracket on the inside of the
frame. The black, padded portion
of the footbar is intended to be
behind the wooden block on the
back of the jumpboard, not pulled
up on it. Gently tighten the black
knobs until snug. See Figure E.
Figure D
Figure E
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | info@pilates.com
400-017 | 09.27.19