Components; Feature List - Ultra Start 25XX Series Install Manual

REMOTE VEHICLE STARTER/ALARM

Components

- Control module
- Antenna with built in
- Program Button and LED's
- Multi-tone Siren
- 14 pin harness
- 4 pin keyless entry harness
- Hood pin safety switch
- Installation and Owner Manuals
* The 26xx comes with two 6 button remote transmitters

Feature List

- Auto Tach learning with Quick Learn option
- Starter Kill/ Anti-Grind Protection
- Remote Panic Feature
- Programmable Wait to Start
- Service Mode (Valet)
- Active/Passive Arming
- Run Time 4/ 15 or 45 minutes
- Door Locks .125s/ .75s/3.0s/Double Unlock
- Cold Start With Four Start Intervals or Temp Mode (LT Models Only)
Recommended Pre-Installation Procedures
Remote car starters and alarms should be professionally installed.
Review the installation and owner manuals and acquire a vehicle wiring diagram for the
vehicle to be worked on. Take a few moments to walk around the vehicle looking for
any damages and make note if any are found. Also check other functions such as
vehicle lighting system, warning lights or check engine lights. Check if the vehicle has a
factory security or anti-theft. (Transponder or PASS-LOCK system) These systems will
require additional parts and labor to complete the installation. Use of the proper tools
and testing equipment is also very important. Never use a grounding style test light to
test for wires in the vehicle. Use only a Circuit Safe test light or digital Volt/Ohm Meter.
It is the sole responsibility of the installer to test and verify all connections
Note: This remote starter system is designed for fuel injected and diesel engines.
If the vehicle is a manual transmission, a "M" series remote starter must be
installed. Any model number followed by the letter "M" is specially designed for
manual transmission vehicles. The "M" series remote starter will not work in an
automatic transmission vehicle.
INSTALLATION MANUAL
- 2 4 button transmitters*
- 6 pin main harness with dual
30 amp power inputs.
- 3 pin auxiliary output harness
- 4 pin Auxiliary sensor harness
- 2 pin Temperature Sensor (LT Models)
- Starter disable harness
- Turbo Timer Mode
- Engine Idle Mode
- System Override Protection
- Dual Car Operation
- Park Light Diagnostics
- Program 4 Transmitter Codes
- Ignition Auto Lock
- Dual Stage Shock Sensor
Page 3