Ultra Start 25XX Series Install Manual page 10

Remote starter/ alarms
Table of Contents

Advertisement

INSTALLATION MANUAL
Page 10
Step 1
- Connect All Of the Following Wires
6 Pin Power Connector
Yellow
30amp Starter Output 12volts during start position only.
Green
30amp Heater Output 12volts in the accessory position off during start and 12volts
Red
30amp Power Input
Red
30amp Power Input
Blue
30amp Ignition Output 12volts in the ignition, start and when run positions.
White
30amp Select Output* Selectable Output for vehicles that require 2nd Ign, Acc or
Note: The white wire may not be required on all vehicles.
Auxiliary Connectors
Black
White
Green/Wht
Blue/White
Pink
White/Blue
Manual Transmission Connections ("M" Models Only)
Black/Wht
Green*
Purple*
Note: Connect only one of the door pin inputs. If the vehicle has a positive door pin system
connect the purple wire, if negative connect the green wire.
Never install an automatic module into a manual transmission vehicle!
Step 2- Plug-In The Module
When all the connections are done, the control module can be plugged in. Before
connecting the control module, make sure the ignition is in the OFF position. Plug in the
6 pin harness and the Auxiliary harness, then any other connectors that were used. The
park lights will flash and the horn will chirp 2 times to confirm power up on automatic
transmission models. Manual transmission models will flash the park lights and siren
4 times to confirm power up.
during the run position.
Constant 12volt power at ignition harness or battery.
Constant 12volt power at ignition harness or battery.
Starter wires. See jumper diagram.
System Ground Input - Connect to Chassis Ground.
Park Light Output - Connect to (+) Park Light system.
Hood Pin Input - Connect to the Hood Pin Safety Switch.
Tach - Connect To A/C Tach Source. (Above 2volts AC)
Brake Switch - Connect To (+) When Brakes Is Applied.
Siren Output - Connect to Siren/Horn
Park Brake Input - Connect to Park Brake wire.
(-) Door Pin Input - Connect to door pin (-) when doors opened.
(+) Door Pin Input - Connect to door pin (+) when doors opened.
REMOTE VEHICLE STARTER/ALARM

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

26xx series25 series26 series

Table of Contents