Ultra Start 430 Series Install Manual page 5

Step 1 - Connect All Of the Following Wires
10 Pin Power Connector
Black Ground Input
Yellow Ignition Input
Red Power Input
Brown (+) Siren Output
White (+) Park lights
Green* (-) Door Input
Purple* (+) Door Input
*Test for door pin type (+ or -) then connect the appropriate wire (Green or Purple)
Step 2- Plug-In The Module
When all the connections are done, the control module can be plugged in. Before
connecting the control module, make sure the ignition is in the OFF position. Plug in the
main harness then any other connectors that were used.
Step 3- Test And Adjust The Shock Sensor
To test the Shock Sensor.
1. Press the Lock button once to arm the system.
2. Wait five seconds then impact the vehicle. Lighter impacts to the vehicle should trigger
the warn away (The siren will chirp three times). A harder impact to the vehicle will trigger
the full alarm.(The siren will activate for 60 seconds then turn off).
3. To deactivate the alarm when triggered, press the unlock button twice.
To Increase The Sensitivity.
Turn the adjustment screw Clockwise 1/4 turn then re-test the sensitivity. Repeat this
procedure until the sensitivity of the system is at the appropriate level.
** Do not set to sensitive.
To Decrease The Sensitivity.
Turn the adjustment screw Counter Clockwise 1/4 turn then re-test the sensitivity. Repeat
this procedure until the sensitivity of the system is at the appropriate level.
Step 4- Test The System
1. Open all the vehicles windows.
2. Press the Lock button to arm the system.
3. Wait five seconds (or until the dome light goes out) then reach in through a window and
open the door. The alarm will then activate (repeat on all the doors).
4. Test the Shock Sensor again and adjust if necessary.
5. Insure that all additional features are working as intended.
6. If necessary proceed to Program Mode to adjust the programmable outputs.
Your Basic Install Is Complete!
System ground input.
Input from vehicles ignition wire.
Constant 12 Volt input.
Positive output for siren.
Positive park light output.
Negative door pin switch input.
Positive door pin switch input.
BASIC INSTALLATION