Magnetek Flex EX2 Charging Instructions
Hide thumbs
Also See for Flex EX2:
- Instruction manual (84 pages) ,
- Quick reference manual (9 pages) ,
- Instruction manual (121 pages)
Advertisement
Flex EX2 Plugin Charging
1
1) Power USB Input
1)
The plugin charger station uses any off-the-shelf Micro USB-to-USB cable and
USB power adaptor with 5V@2A output (not included).
2)
Connect the charging plug onto the charging connector on battery cover.
Instructions
2
2)
Charging Status LED
Page 1
3
3)
Charging Plug
Advertisement
Table of Contents
Related Manuals for Magnetek Flex EX2
Summary of Contents for Magnetek Flex EX2
- Page 1 Flex EX2 Plugin Charging Instructions 1) Power USB Input Charging Status LED Charging Plug The plugin charger station uses any off-the-shelf Micro USB-to-USB cable and USB power adaptor with 5V@2A output (not included). Connect the charging plug onto the charging connector on battery cover.
- Page 2 Make sure the marking on the charging plug (see below) is facing the top side when connecting. 4) The transmitter is designed to accept any off-the-shelf Ni-MH rechargeable batteries. Depending on the battery capacity the average charging time is approximately 1.5 hours from completely drained to fully charged. Constant red on the LED represents charging in progress, constant green represents batteries fully charged, and LED off represents no batteries detected.
Need help?
Do you have a question about the Flex EX2 and is the answer not in the manual?
Questions and answers