Ports (More Settings) - HIKVISION DS-7100NI-Q1 Series User Manual

2. Turn on Enable.
3. Select Mapping Type as Manual or Auto
Auto The port mapping items are read-only, and the external ports are set by the router
automatically. You can click Refresh to get the latest status of the port mapping.
Manual Select an external port type. Click
external port No., or change it according to actual requirements. External Port
indicates the port No. for port mapping in the router.
The value of the RTSP port No. should be 554 or between 1024 and 65535, while
the value of the other ports should be between 1 and 65535 and the value must
be different from each other. If multiple devices are configured for the UPnP™
settings under the same router, the value of the port No. for each device should
be unique.
4. Set the virtual server of your router, including internal source port, external source port, etc.
The virtual server parameters shall be corresponding with your device port.

6.2.4 Ports (More Settings)

Set different port types to enable relevant functions as your desire.
Go to Configuration → Network → General → More Settings .
Alarm Host IP/Port
The device will send the alarm event or exception message to the alarm host when an alarm is
triggered. The remote alarm host must have the client management system (CMS) software
installed.
Alarm Host IP refers to the IP address of the remote PC on which the CMS software (e.g.,
iVMS-4200) is installed, and the Alarm Host Port (7200 by default) must be the same as the
alarm monitoring port configured in the software.
Server Port
For remote client software access. Ranges from 2000 to 65535. The default value is 8000.
HTTP Port
Network Video Recorder User Manual
Figure 6-7 NAT
to edit External Port. You can use the default
43