Jumper Settings; How To Set Jumpers; Cmos Clear (Cmos1); Jlvds1 / Jlvds2: Lcd Power 3.3 V/5 V/ 12 V Selector - Advantech AIMB-233 User Manual

1.8

Jumper Settings

This section provides instructions on how to configure your motherboard by setting
the jumpers. It also includes the motherboards's default settings and your options for
each jumper.
1.8.1

How to Set Jumpers

You can configure your motherboard to match the needs of your application by set-
ting the jumpers. A jumper is a metal bridge that closes an electrical circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that slides
over the pins to connect them. To "close" (or turn ON) a jumper, you connect the pins
with the clip. To "open" (or turn OFF) a jumper, you remove the clip. Sometimes a
jumper consists of a set of three pins, labeled 1, 2, and 3. In this case you connect
either pins 1 and 2, or 2 and 3. A pair of needle-nose pliers may be useful when set-
ting jumpers.
1.8.2 CMOS Clear (JCMOS1)
The AIMB-233 motherboard contains a jumper that can erase CMOS data and reset
the system BIOS information. Normally this jumper should be set with pins 1-2
closed. If you want to reset the CMOS data, set CMOS1 to 2-3 closed for just a few
seconds, and then move the jumper back to 1-2 closed. This procedure will reset the
CMOS to its default setting.
Table 1.3: CMOS1
Function
*Keep CMOS data
Clear CMOS data
* Default
1.8.3 JLVDS1 : LCD Power 3.3 V/5 V/ 12 V Selector
Table 1.4: JLVDS1/JLVDS2: LCD Power 3.3 V/5 V/ 12 V Selector
Closed Pins
JLVDS1
3-4
4-6
2-4
Default
*
Jumper Setting
1-2 closed
2-3 closed
Result
Jumper for 12 V LVDS panel
Jumper for 3.3 V LVDS panel*
Jumper for 5 V LVDS panel
7 AIMB-233 User Manual