2 SETUP
4
–
Position the handlebar clamps. Mount and tighten the screws
evenly.
Guideline
Screw, handlebar
clamp
Info
Keep the installed gap widths equal when tightening.
–
Align the controls of the left handlebar half with the markings
on the handlebar. Tighten the screws.
Guideline
Screw, combination
switch, left
–
Position clutch assembly on the handlebar.
–
Position the clutch assembly clamp on the handlebar.
–
Mount and tighten screws
V01338-10
Guideline
Remaining screws,
chassis
–
Align the control of the right handlebar half with the markings
on the handlebar. Tighten the screws.
Guideline
Screw, throttle grip
Screw, combination
switch, right
–
Check the throttle grip for smooth operation.
V01339-10
–
Position brake assembly on the handlebar.
–
Position brake assembly clamp on the handlebar.
Clamp catch engages in the combination switch.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
–
Tie the cables together with the rubber bands supplied.
–
Mount and tighten the rear mirror on both sides.
V01340-01
M8
20 Nm (14.8 lbf ft)
M5
2 Nm (1.5 lbf ft)
4
.
M6
10 Nm (7.4 lbf ft)
M5
3.5 Nm
(2.58 lbf ft)
M5
5 Nm (3.7 lbf ft)
5
.
M6
10 Nm (7.4 lbf ft)