Built-In Installation; Initial Start-Up - U-Line pmn User Manual

User's Manual
6. Holding door gasket out of the way, replace handle on door mak-
ing sure it is seated properly on insert and that screw holes line
up.
7. Install two small screws removed in step 2.
8. Starting at the corners and working inward, push door gasket into
place on door.
9. Place door on bottom hinge pin and install upper hinge screw.

BUILT-IN INSTALLATION

Your U-Line product has been designed for either free-standing or built-
in installation. When built-in, your U-Line product does not require addi-
tional air space for top, sides, or rear. However, the front grille must
NOT be obstructed.
To ease unit installation and removal, it is recommended
that the cabinet rough opening dimensions be increased by
at least 1/4" over the dimensions given for your unit.
Model
2015 Series
2075 Series
* For full overlay door panels, add 3/4".
Once installation is complete, the unit is ready for initial start-up and
operation.
CONTROL SETTINGS-COMBO/REFRIGERATOR
Models 2015R, 2075R and
2075RF are turned ON with the
control knob located on the grille.
Turn the knob clockwise for ON,
counterclockwise for OFF. Models
2015R, 2075R and 2075RF
turn OFF when the temperature
control is turned counterclock-
wise all the way toward warmer
until it stops (until "click" is heard).
NOTE
Unit Dimensions
Width
14-15/16"
23-15/16"

INITIAL START-UP

14
Height
34-1/8"
34-1/8"
4
3
5
2
7
1
Figure 18
Depth*
24"
24"
6
UL315