Carson Bluster 400 3D Instruction Manual page 7

Lithium-Polymer battery
Employ the enclosed battery exclusively for this model.
Only employ an original part as the replacement battery.
• Load the battery exclusively outside of the model and away
from easily flammable materials! It is normal that the battery
warms up when charging.
• Do not overload or exhaustively discharge the battery!
• Pay attention to the charge indicators on your transmitter.
• Ensure that the batteries for the radio and receiver are fully
charged and of the correct voltage. When the batteries are
running low you might loose control of your model.
• Charge the LiPo battery at least every six months in order to
avoid low discharging.
• Remove the charged battery from the battery charger in
order to avoid self-discharging. If not using the model for a
longer time, the rechargeable battery has to be removed.
At the end of its useful life, under various national / state and
local laws, it may be illegal to dispose of this battery into the
municipal waste stream. Check with your local solid waste
officials for details in your area for recycling options or proper
disposal.
The batteries must not
• be immersed in liquid,
• be thrown in the fire or subjected to high temperatures or
• mechanical stresses or
• be taken apart or damaged
• or be short-circuited
If during operation or while charging or storing the battery you
perceive a noticeable smell, a discolouration, excessive heating
or deformation or any other abnormality:
• disconnect the battery from the battery charger
• Separate the battery from the consumer
• no longer employ the battery.
If electrolyte drains out:
• avoid contact with eyes and skin!
• Wash the affected locations immediately with clear water
and
• consult a physician.
CARSON 3D Helicopter Bluster 507012
GB
7