Preparations - Carson Bluster 400 3D Instruction Manual

5. Adjust the reverse switch on the gyroscope:
Turn the helicopter towards the left. If the servo movement
on the rear servo rotor is the same as if the left control stick
on the transmitter is moved towards the right, then the
direction is ok. If this is not the case, then you must reverse
the reverse switch on the gyroscope.
6. Adjust spinner/gyro-sensitivity (gain):
Keep an eye on the rear end when flying the helicopter for
the first time. If the rear end always veers more towards the
right or the left, the rotary gain potentiometer (adjuster for
rotary potentiometer) must be turned further towards „+"
until the rear end stabilises whilst hovering.
If the rear end starts to kick out jerkily then the gyro-
sensitivity (gain) must be adjusted a little more towards „-"
again.
Tip:
It is better to increase the gyroscope's sensitivity a little
if the rear end is not kicking out jerkily.
d. Preparations
General remarks
• If you have no or little experience with airplane models, you
should first practice with a Flight simulation program.
• Seek advice from an experienced R/C user for the first few
attempts.
• Acquaint yourself with the control functions of the
transmitter.
• Begin your flight experiments standing behind the model,
the line of sight in the flight direction. In this case, the control
reaction is the same as the direction of control.
Furthermore acquaint yourself with the control of the model as
it comes towards you (side-inverted reaction to the direction of
control)!
Lipo Balance Charger
Charging the lithium-polymer flight
battery.
Always charge the lithium-polymer battery out of the model
in/on a fireproof base.
1. Connect the power supply to the lithium-polymer balance
charger.
2. Plug the power supply cable into a mains socket.
3. Connect the white connector of the lithium-polymer battery
to the socket of the lithium-polymer charger.
4. Ensure that the plug-in connections make a secure contact
to prevent short-circuiting.
5. Do not cover the battery up under any circumstances.
The temperature of the battery may not exceed 60 °C during
the charging process. The charging process is complete when
the green LED lights up on the balance charger.
• Connect the lipo balance charger to the power
• Connect the lipo battery's white balance
• The battery is completely charged when all
CARSON 3D Helicopter Bluster 507012
1. Anschluss zum Heck-Servo
2. Gain-Justierung
3. Kontrollleuchte
4. Reverse-Schalter
5. Anschluss zu CH4
6. Kreisel-Gain-Anschluss zu CH5
supply's cable.
connector to the lipo balance charger.
3 leds flash up green.
GB
11