Functions For Control Set; Assembly Gyro - Carson Bluster 400 3D Instruction Manual

b. Functions for control set
GB
Mode II above
Switch for gyro:
Backwards, the gyro is in
heading-lock mode
Forwards, the gyro is in
normal gyro-operation
PIT
Left joystick
CH3 trim adjustment
CH4 trim adjustment
Crystal socket
on the rear
PIT: This switch that controls the settings for pitch
adjustment. The starting setting should be with the knob
set to the 10:00 o'clock position.
PLT: This is the pitch end point position knob. The initial setting
should be set at 1:00 o'clock position.
Picture of control set connection
c. Assembly Gyro:
1. Ensure that the wireless remote controller and the servos are
working perfectly and that the servo arms are in the correct
position.
2. Attach the gyroscope in an absolutely horizontal position.
3. Plug the CH4 and CH5 servo connectors into the appropriate
slots on the receiver. Attach the rear servo to the gyroscope.
10 CARSON 3D Helicopter Bluster 507012
6. Pitch
5. Gyro gain
4. Rudder
3. Throttle
2. Elevator
1. Aileron
4. Switch the transmitter on and centre the trimming lever to
Move the control extremely
delicately!
the middle. Connect the flight battery and wait until the LED
on the gyroscope lights up. The gyroscope will then start a
test run of the functions. The LED blinks for approx. 10
seconds and than stays alightened. The gyroscope is ready
for operation. If not, you must check to ensure that the con-
nections are ok and start the installation process over again.
LCD-Display
3D Mode/Normal mode
PLT
Switch for Dualrate
(100% > 70%)
for channel 1, 2 und 4
Right joystick
CH2 trim adjustment
CH1 trim adjustment
Power switch
Keylock - Lock/Locked
Reverse switch on pitch
Reverse switch on tail rotor
Reverse switch on throttle
Reverse switch on nick
Reverse switch roll