Page 1
YS300 NO BARK COLLAR Owner's Manual Please read this manual thoroughly before operating the YS300.
Page 2
Dogtra product. Failure to follow these damage. safety instructions could result in injury to you, your dog and others, or it could result in damage to your Dogtra Medical Device Interference product or other property. Dogtra products contain electrical and magnetic...
CONTENTS UNAUTHORIZED USE Your Dogtra product should be used only in a humane AT A GLANCE ..............manner to train and educate your dog. Dogtra products are MAIN FEATURES ............not intended for use in any other manner nor are they intended for use with other animals or with humans.
Receptacle • Pager vibration (P) warning prior to the stimulation & Rubber Plug • 6 intensity levels (2-7) for a wide variety of dispositions • Test mode (T) for testing the YS300 • Fully waterproof receiver Contact Points • Medium output receiver •...
- The YS300 has stimulation levels 2 (lowest) through 7 (highest). Each stimulation level begins with a vibration and is followed by the stimulation. - Set the dial to "T' to test the YS300. See TESTING THE YS300 on page 11 to check if your unit is working properly.
LED INDICATOR The LED indicator light will flash for 1 second when the 1. Turn the dial on the YS300 to "T" to set the system to YS300 has been turned on and then flash every 2 seconds. test mode.
Note 2: The unit has a partial charge when it leaves the Dogtra facility. Upon receipt of the collar, be sure to give it a full 2-hour initial charge before the first use. When a...
The red light will turn green once the unit is loose, the contact will not be consistent and cause the fully charged. corrections to be inconsistent. Dogtra uses surgical 4. After charging, cover the battery charging receptacle stainless steel contact points and anti-microbial plastic to with the rubber plug on the receiver.
Remove all other collars when there is no damage to the casing, rinse the receiver and using the YS300 since additional collars or buckles may clean out any dirt or debris. inadvertently activate the unit.
(response may be very subtle). 2. My YS300 is not holding a charge. – The batteries might not be charged properly, or the charger, splitter, and the charging port may not be functioning properly.
Page 11
(“You”) that its Dogtra products shall be free of defects in materials Dogtra’s liability is limited to the cost of repair or replacement of the Dogtra and workmanship for a period of one (1) year from the date of purchase product under Warranty.
Page 12
Upon approval of your warranty work, Dogtra will repair or replace (at Dogtra’s election) your product without charge for labor or parts. You are responsible for shipping, including cost, of your product to Dogtra for warranty service. Dogtra will handle shipping, including cost, of the repaired or replaced product back to customers in the USA.