Page 2
By Dogtra No Bark Collars Owner's Manual Please read this manual thoroughly before using the YS600.
Page 3
1. The YS600 is intended to prevent the barking of dogs only. It is NOT intended for use on people or on animals other than dogs. Dogtra does not assume any liability for the improper use of the YS600. 2. Leaving the YS600 in the same position on a dog’s neck for extended periods of time can cause skin irritation.
Table of Contents At a Glance ............Main Features ............ Overview ............How to Use the On/Off & Intensity Dial ....The LED Indicator ..........Operating Modes ..........The Persistent Bark Indicator ........ Testing the YS600 ..........Charging the Battery ..........
At a Glance YS600 Battery Owner’ s No Bark Collar charger Manual Main Features Contoured Design 2-Hour Rapid Receiver/Collar Charge Batteries Persistent Bark Intensity Levels Indicator 1-10 Non-Stimulating Accelerometer High Performance Bark Sensor Pager Enhanced Contact For Dogs as Small Points as 35 lbs.
How to Use the On/Off & Intensity Dial - The On/Off Intensity Dial is used to turn the No Bark Collar on/off and to select the stimulation intensity level. - Set the dial to “.” to turn off the No Bark Collar. - Set the dial to “P”...
The LED Indicator The LED indicator will flash for 1 second when the YS600 has been turned on, and every 4 seconds afterwards. If your dog does not bark for over 30 seconds, the LED indicator will turn off and the YS600 will go into a sleep mode to conserve battery life.
The Persistent Bark Indicator The Persistent Bark Indicator activates when the unit is turned off and when there has been excessive barking. 1. Without excessive barking: – The LED will glow red for 2 seconds when the unit is turned off. 2.
Testing the YS600 1. Turn the dial to “T”. The LED indicator will blink once every 4 seconds. 2. Use the cap end of a ballpoint pen and scratch between the contact points. The unit is working properly when it vibrates twice.
3. While the battery is recharging, the LED will stay on red. The LED light will become green when the battery is completely recharged (the battery is fully charged after 2 hours). Note: Only use Dogtra approved Lithium Polymer Battery chargers designed for the YS600. Non-Dogtra chargers could potentially damage the unit.
Collar Fitting It is important to have a proper fit. A loose fit will provide an inconsistent stimulation and the unit will move around on your dog’s neck, which may cause irritation. With a proper fit, you should be able to fit a finger or two snugly between the contact points and your dog’s skin.
- The contact points may be too short for your dog’s thick or long coat. To place an order for longer contact points, please contact Dogtra or a Dogtra dealer. If you are already using longer contact points, you may need to trim the hair on the dog’s neck, so that both contact points are touching the dog’s skin.
Page 14
3. My dog has skin irritation. - This may be due to an improper fit or from wearing the unit too long. If your dog exhibits signs of skin irritation, consult with a veterinarian. Once the dog’s skin returns to a normal condition, continue to use the collar and check your dog’s neck each time you use the unit.
If your product is not registered and a proof of purchase is not available at the time of service, Dogtra will estimate the age of the unit by the serial number. Serial number estimates can differ from the actual purchase date.
Page 16
Dogtra is not responsible for units damaged or lost in transition to Dogtra. Dogtra is not responsible for loss of training time or inconvenience while the unit is in for repair work. Dogtra does not provide loaner units or any form of compensation during the repair period.
Need help?
Do you have a question about the YS 600 and is the answer not in the manual?
Questions and answers