Table of Contents
Advertisement
CAS1000 – TEST MODE ... continued
SLAVE SIDE
CAS1000 is in
Test Mode
Press the first Blank button on the On Board
controls
On board controls (Master)
On board controls (Slave)
This button turns the
Fuelbed LEDs on or off
during test mode
Bluetooth Receiver
Remote Control
O
To exit Test Mode,
I
Press switch off (O)
Note: When in Test Mode, the CAS1000 will revert to standby mode if there are
no buttons pressed after a period of 16 seconds. Any parts that may have been
switched on during testing will also switch off.
Page 38 of 39
Advertisement
Table of Contents
