Table of Contents
Advertisement
CAS500 – TEST MODE ... continued
CAS500 is in
Test Mode
Press the On/Standby button on the On
Board controls
On board controls
This button turns the
Fuelbed LEDs on or off
during test mode
Bluetooth Receiver
Remote control
O
To exit Test Mode,
I
Press switch off (O)
Note: When in Test Mode, the CAS500 will revert to standby mode if there are
no buttons pressed after a period of 16 seconds. Any parts that may have been
switched on during testing will also switch off.
Page 16 of 39
Advertisement
Table of Contents
