Switching On And Off; Speed Control; Led Work Light - Parkside PSSAP 20-Li B2 Operation And Safety Notes

Removing the saw blade
(Fig . G)
Turn the chuck ring 2 in a counter-clockwise
¾
direction .
Pull the saw blade out of the saw blade
¾
holder 3 .
Release the chuck ring 2 and let it return to
¾
its original position .
NOTE
For certain work, the saw blade can also
u
be inserted after turning through 180° .
˜ Switching on and off
m
CAUTION! RISK OF INJURY!
Always wear protective gloves when
handling or working with the product .
m
CAUTION! RISK OF INJURY!
Before switching on the product: Ensure
u
the saw blade is not in contact with the
workpiece .
Ensure your stance is stable . Always hold
u
the product's front 9 and rear handle
7 firmly with both hands while working
(Fig . H) .
Keep your hands away from the saw
u
blade when the product is in operation .
NOTE
The on/off switch 6 cannot be locked .
u
(Fig . I)
Switching on: Release the switch lock 5
¾
by pushing it in on the left or right side .
Press and hold the on/off switch 6 .
Regulate the speed as required (see "Speed
control") .
Switching off: Release the on/off switch
¾
6 .
When releasing the on/off switch, the switch
lock 5 moves back into its original position .
˜ Speed control
By using the on/off switch 6 , you can
¾
progressively control the speed:
Pressure
Gentle pressure:
Greater pressure:
˜ LED work light
This product is equipped with a LED work light
10 to illuminate the immediate working area to
improve visibility in poorly lit areas .
The LED work light 10 lights up automatically
¾
as soon as the product is switched on .
NOTE
The LED work light 10 stays on for an
u
additional approx . 10 seconds after
switching off the product .
Speed
Lower speed
Higher speed
GB/IE 37