Vrm Installation; Peripheral Device Installation; Connecting The Power Supply - TYAN S1668 User Manual

3.12 VRM Installation

The VRM is required for the Pentium Pro to work. The CPU will
program the VRM for the correct voltage needed. No jumper settings
are needed, just install the VRM into the VRM socket nearest the
CPU that is being installed. The VRM can only fit in the socket one
way so there is no danger of installing it incorrectly. Not all VRM's
will work in the S1668. Make sure you purchased a qualified VRM.
VRM socket 0 is for CPU socket 0.
VRM socket 1 is for CPU socket 1.

3.13 Peripheral Device Installation

After all the jumpers on the mainboard have been set, then it can be mounted
into the case. Then proceed to install the display card and any other
peripheral devices.
If a PCI-Bus interface card is to be installed in the system, any one of the
four PCI-Bus slots can support either a Master or a Slave device.
After installing the peripheral controller, the user should check everything
again, and prepare to power-on the system.
3.14 Connecting the Power Supply & On/Off Switch
The system power supply connectors on the mainboard is for a
standard ATX power supply. It can only be plugged in one way and
should install in easily.
ATX cases have an on/off switch that can be used to turn on or off
the ATX powersupply without having to use the switch that is on
the back of the powersupply.Use jumper J1 is for the on/off button from the
system case.
S1668-ATX-001 http://www.tyan.com 16