Mitsubishi MOTORS L200 Owner's Manual page 355

Tyre size
245/70R16 111S RF
245/65R17 111S RF
*
: On vehicles with 195 size tyres, this size of snow tyres can also be used instead.
Check the tyre inflation pressure of all the tyres while they are cold; if insufficient or excessive, adjust to the specified value.
After the tyre inflation pressure has been adjusted, check the tyres for damage and air leaks. Be sure to put caps on the valves.
Wheel condition
1- Location of the tread wear indicator
2- Tread wear indicator
UP TO 3 PASSENGERS
Front
2.0 bar
(200 kPa) (200 kPa)
{29 psi} {29 psi}
2.0 bar
(200 kPa) (200 kPa)
{29 psi} {29 psi}
Check the tyres for cuts, cracks and other
damage. Replace the tyres if there are deep
E01001800797
cuts or cracks. Also check each tyre for
pieces of metal or pebbles.
The use of worn tyres can be very dangerous
because of the greater chance of skidding or
hydroplaning. The tread depth of the tyres
must exceed 1.6 mm in order for the tyres to
meet the minimum requirement for use.
If there are tread wear indicators on the tyres,
they will appear in six places on the surface
of the tyre as the tyre wears, thereby indicat-
ing that the tyre no longer meets the mini-
mum requirement for use. When these wear
indicators appear, the tyres must be replaced
with new ones.
MAX. LOAD OR TRAILER TOWING
Rear Front
2.0 bar 2.0 bar
(200 kPa)
{29 psi}
2.0 bar 2.0 bar
(200 kPa)
{29 psi}
Check that the wheel nuts are tightened cor-
rectly. Refer to the section entitled "For
emergencies" for information concerning re-
placement of the tyres.
On 4-wheel drive vehicles, when replacement
of any of the tyres is necessary, replace all of
them.
OKTE15E3
Rear
2.9 bar
(290 kPa)
{42 psi}
2.9 bar
(290 kPa)
{42 psi}
NOTE
l The mark and the location of the tyre tread
wear indicators are different depending on
the tyre manufacturer.
Maintenance
Tyres
10
10-13