Page 1
NT block to maintain superior connectivity through hundreds of ® reterminations and deliver the best electrical performance in the industry. The LSA-PLUS NT block is a high–density solution that utilizes the silver plated, world renowned LSA-PLUS contact principle. Its gas-tight contacts ensure a reliable and long lasting connection.
Page 2
Clear labeling system eliminates wiring mistakes • Built in “look-both-ways” test port • Designed for use with ADC back mount frame; other versions are available for use with ADC profile rod mount brackets • Various identification and marking possibilities: marking caps used to mark...
LSA-PLUS NT Termination Blocks ® Specifications MECHANICAL W ire range for solid copper conductors (single wire per contact): W ire range for stranded tinned copper conductors (single wire per contact): Two wires per contact (same gauge): Wire insulation diameter range (PE, PVC): Number of wire terminations: Number of disconnect port plug-in cycles: ELECTRICAL NEXT (average worst case performance): Insulation resistance: Contact resistance: Electrical strength / impulse strength: Operation voltage for basic insulation (B/S): Transient overvoltage for B/S insulation: Current carrying capacity: Impulse current: Air gap / creepage: ENVIRONMENTAL AND SAFETY Safety Compliance: Flammability rating of plastic housing: Storage temperature range: Operating temperature range: Telcordia compliance: ® MATERIALS Plastics: Contact plating: Equipment Side of Block 112 mm (4.4") Cross-Connect Side of Block w w w .
Page 4
Specifications published here are current as of the date of publication of this document. Because we are continuously improving our products, ADC reserves the right to change specifications without prior notice. At any time, you may verify product specifications by contacting our headquarters office in Minneapolis. ADC Telecommunications, Inc.