8. Do not operate unit with a damaged power cord or if the unit has been dropped or damaged. To avoid risk of electrical shock, do not disassemble unit; contact Steamfast Consumer Service for examination and repair. Incorrect reassembly can cause a risk of electrical shock when unit is used.
Page 3
Steamfast Consumer Service at 1-800-711-6617. Please refer to our website for the most current version of our owner’s guide.
Product Information The following features and accessories are included with your Everyday Fabric Steamer. Carefully inspect the packing material for all parts listed below. To obtain possible missing parts, refer to Product Support on Page 14 of this manual for Consumer Service contact information. UNIT FEATURES &...
Page 5
• The Steam Nozzle (1) emits the flow of hot, penetrating steam produced by the Boiler. The Fabric Brush connects to the Steam Nozzle. • The Pole Top (2) connects to the top section of the Telescopic Pole. The Pole Top is comprised of the Steam Nozzle Cradle and Clothes Hanger Hooks, and includes the Hanger Anchor Holes.
Page 6
Assembling Your Everyday Fabric Steamer TELESCOPIC POLE The Telescopic Pole is made up of four sections (FIGURE 1): • TOP (SECTION 1) • MIDDLE-TOP (SECTION 2) • MIDDLE-BOTTOM (SECTION 3) • BOTTOM (SECTION 4) SECTION 1 SECTION 2 SECTION 3 SECTION 4 (TOP) (MIDDLE-TOP)
Page 7
CONNECTING POLE TOP 1. Look at underside of Pole Top to locate two guide ridges (FIGURE 3-A). 2. Align Pole Top guide ridges with guide grooves on SECTION 1 of Telescopic Pole. NOTE: It is recommended to orient Pole Top so Nozzle Cradle faces backwards towards rear of the unit.
3. Press Fabric Brush firmly onto Steam Nozzle. The two pegs will fit into the two larger holes on face of the nozzle, while latch fits over top of the nozzle (FIGURE 7-A). Your new SF-510 Everyday Fabric Steamer is now fully assembled and ready for use.
Using Your Everyday Fabric Steamer FILLING WITH WATER 1. Remove Water Tank from main unit. 2. Holding Water Tank upside-down, unscrew and remove Valve Cap by rotating it in a counter- clockwise direction (FIGURE 8-A). 3. Fill Water Tank with water through Valve Cap hole. At full capacity, the Water Tank holds 46 oz (1,360 ml) of water, and will provide a continuous steam time of approximately 50 minutes.
Using Your Everyday Fabric Steamer GENERAL OPERATION NOTE: Be sure that Water Tank has been filled and, if desired, the Fabric Brush is connected before following these steps. 1. For first-time use, remove protective plastic cover that is shipped on electrical plug. Plug power cord into a convenient electrical outlet.
Page 11
FABRIC STEAMING STEAMING GARMENTS: 1. To expand Hanger for use, fold the two arms upward until the lower support arms line up straight (FIGURE 9-A). Slide lock to secure arms in place (FIGURE 9-B). A garment may now be placed on the Hanger. 2.
5. Open Drain Plug and drain all remaining water from Water Reservoir. Securely replace Drain Plug. 6. Mix one packet of Steamfast Lemon Acid in 8 oz (236 ml) of warm tap water, and stir solution until dissolved. CAUTION: Only Steamfast Lemon Acid should be used in the Everyday Fabric Steamer.
For problems with your Everyday Fabric Steamer, please refer to the troubleshooting guide located above. Additional inquiries should be directed to our consumer support services through our Web site, www.steamfast.com. If you do not have internet access, you may also contact our Consumer Service Department by telephone, at 1-800-711-6617.
When ordering replacement accessories for your Everyday Fabric Steamer, you may refer to the part numbers below. Replacement accessories may be ordered through our Web site: www.steamfast.com You may also contact Consumer Service directly: consumerservice@steamfast.com or 1-800-711-6617 FABRIC BRUSH HANGER A510-001R- A510-002R- NOTE: Due to continuing improvements, part numbers listed above may change.
Owner’s Guide (the “Warranty Period”). In the event Buyer notifies Steamfast of a defect in the Product within the Warranty Period, Steamfast will replace the Product and/or defective component parts, as applicable and necessary. Any...
Page 16
All such fees and costs shall be the sole responsibility of Buyer. Please allow at least 1-2 weeks for return of the Product after it is received by Steamfast. For ease of recordkeeping, it is recommended that Buyer staple or attached the original sales receipt to this Owner’s Guide and record the Product serial number (located on the Product specifications...
Need help?
Do you have a question about the SF-510 and is the answer not in the manual?
Questions and answers