Led Indicators - Weidmuller IE-WL-AP-BR-CL-ABG-EU Hardware Installation Manual

LED Indicators

The front panel of Weidmüller's IE-WL-AP-BR-CL-ABG contains several
LED indicators. The function of each LED is described in the table below.
LED Color State
Front Panel LED Indicators (System)
On
PWR1 Green
Off
On
PWR2 Green
Off
On
PoE Amber
Off
Blink
(slow)
FAULT Red
Blink
(fast)
Off
Green
Green/Re
Green
STATE
d
Blink
Red
SIGNAL On
Green
(5 LEDs) Off
On
BRIDGE
Green
MODE
Off
On
CLIENT
Green
MODE
Off
On
WLAN Amber
Off
TP Port LED Indicators (Port Interface)
On
100M Green
Blink
Off
On
10M Yellow
Blink
Off
Description
Power is being supplied from power
input 1.
Power is not being supplied from
power input 1.
Power is being supplied from power
input 2.
Power is not being supplied from
power input 2.
Power is being supplied via PoE.
Power is not being supplied via PoE.
Cannot get an IP address from the
DHCP server (interval: 1 sec)
IP address conflict (interval: 0.5 sec)
Error condition does not exist.
Software Ready
The IE-WL-AP-BR-CL-ABG has been
located by Weidmüller WLAN
Administrator. (interval: 1sec)
Booting error condition
Signal level
(for Client mode only)
IE-WL-AP-BR-CL-ABG functions in
Bridge Mode.
IE-WL-AP-BR-CL-ABG is not in Bridge
Mode.
IE-WL-AP-BR-CL-ABG functions in
Client Mode.
IE-WL-AP-BR-CL-ABG is not in Client
Mode.
WLAN is in used
WLAN is not in use
TP port's 100Mbps link is active.
Data is being transmitted at 100 Mbps
TP port's 100Mbps link is inactive.
TP port's 10Mbps link is active.
Data is being transmitted at 10 Mbps
TP port's 10Mbps link is inactive.
- 11 -