Table of Contents
Advertisement
Testing method for two or more IE-WL-AP-BR-CL-ABGs
If you have two or more IE-WL-AP-BR-CL-ABGs, you will need a second
notebook computer (B) equipped with an Ethernet port. Use the default
settings for the first IE-WL-AP-BR-CL-ABG connected to notebook A, and
change the second or third IE-WL-AP-BR-CL-ABG connected to notebook
B to Client mode and then configure the notebooks and
IE-WL-AP-BR-CL-ABGs properly.
After setting up the testing environment, open a DOS window on
notebook B. At the prompt, type
ping IP address of notebook A
and then press Enter key. A "Reply from IP address ..." response means
the communication was successful. A "Request timed out." response
means the communication failed. In this case, recheck the configuration
to make sure the connections are correct.
Panel Layout of IE-WL-AP-BR-CL-ABG
Top Panel View
Front Panel View
Rear Panel View
1. Grounding screw
2. Terminal block for PWR1, PWR2,
relay, DI1, and DI2
3. Reset button
4. Heat dissipation orifices
5. System LEDs: PWR1, PWR2,
PoE, FAULT, and STATE LEDs
6. LEDs for signal strength
7. WLAN LEDs: CLIENT BRIDGE,
and WLAN LEDs
8. RS-232 console port
9. 10/100BaseT(X) RJ45 Port
10. 10M LED
11. 100M LED
12. MAIN antenna port
13. AUX antenna port
14. Article number
15. Screw hole for wall mounting kit
16. DIN-Rail mounting kit
- 4 -
Advertisement
Table of Contents
