Table of Contents
Advertisement
2.4 Safety information for the user company
The superiors of the operating personnel must have understood and must comply with Chapter "Safety
information" and the aspects of operation relevant to safety. They must ensure that the operating per-
sonnel have understood and follow the safety information.
Before placing the unit into operation, superiors must check that operation of the D
junction with other installations or system sections cannot pose additional risks and dangers.
If necessary, additional technical safety instructions must be drawn up by superiors. In order to preclude
the possibility of residual risks and dangers, the company using the D
up in-company instructions and have receipt of these instructions confirmed by the personnel responsi-
ble. Moreover, the user company must stipulate the scopes of authority for working with the D
1000 so that there are clear scopes of authority in relation to technical safety aspects.
2.5 No arbitrary conversion work or modification work
No modifications may be made to the D
placed only by original parts. Neither the design nor the technical safety systems of the D
may be modified without our express consent. In particular, no modifications to safety facilities are per-
mitted. Modifications of any nature will exempt us from liability for resultant damage and injury.
2.6 Supplementary safety information
1. The D
P
may be used only for the intended application as stated and for no other purposes.
OSI
UMP
2. Maintenance work and repair work may be carried out only by qualified staff.
3. The unit must be installed in such a manner that the On/Off switch is easily accessible at all times.
4. Should a situation arise in which safe operation of the D
the unit must be placed out of operation and locked until it can be repaired by qualified staff. Such a
situation must be assumed if:
- there is visible damage to the D
- the D
P
1000 is no longer working or
OSI
UMP
- the mains-circuit over current release trips.
5. Disconnect the D
6. Connect the power cables of the D
avoid electric shock. Do not use adapters for plugs and do not remove earthing connections from
cables. If an extension cable has to be used, please use only three-core cable with correctly earthed
plugs.
7. Ensure that all cables and tubes are laid in a safe area to prevent the risk of tripping over them.
8. Do not spill food or liquids on the D
1000 requires cleaning.
2.7 Warranty and liability
BioTool Swiss AG provides warranty for this unit covering defects in relation to both components and
design. The unit has been thoroughly inspected in order to ensure that it complies with the specifica-
tions published. BioTool Swiss AG guarantees that this unit will remain free of defects for a period of 18
months as of the date of delivery. This warranty shall be rendered null and void if the unit is not operat-
ed by a trained person in accordance with the instructions supplied by BioTool Swiss AG or if an un-
qualified person attempts to repair the unit.
NOTE
Page 7 / 24
OSI
P
OSI
UMP
P
1000 from the mains power supply before moving it to a new location.
OSI
UMP
OSI
OSI
Parts subject to wear are not covered by warranty.
P
1000. In particular, defective components may be re-
UMP
P
OSI
1000,
P
1000 only to a fully earthed mains system in order to
UMP
P
1000. Please read the technical guide if the D
UMP
DosiPump 1000 User Manual
OSI
P
1000 may need to draw
OSI
UMP
1000 can no longer be guaranteed,
UMP
P
1000 in con-
UMP
P
OSI
UMP
P
1000
OSI
UMP
P
OSI
UMP
Version 1.01E
Advertisement
Table of Contents
