Error Codes - True Fitness Z7 Series Owner's Manual

Error Codes

C M
ARE AND AINTENANCE
Or to indicate an error in speed or incline:
INVALID INCLINE DATA
INVALID SPEED DATA
CALIBRATION ABORTED:
NO SPEED SENSOR
4. Remove and replace Safety Key and exit Calibration Mode
The following Error Codes and Service Codes will follow a double "beep"
and show on the display. Service Codes provide preventative maintenance
reminders. A Service Code will repeat for the next five times you start the
treadmill. A Service Code will clear after any key has been pressed. When
an Error Code occurs, call an authorized service technician.
Z7
E1: MINIMUM
E1:RANGE
E1:STALL
E1:INCLINE
E2:OVERSPEED
E2:CAL
E2:RECAL
E5:SENSOR
Z 7 T r e a d m i l l O w n e r ' s G u i d e
62
DESCRIPTION
This error occurs when the incline values on the
display do not match the values stored during calibra-
This error occurs when the incline motor does not
move in response to an incline command.
This error occurs when the incline motor moved
without an incline command.
This error occurs when acceleration exceeded design
This error occurs when the speed displayed does not
match the stored value from calibration.
This error occurs when a data error is detected at start
up. The Control Panel has reset to default values.
This error occurs when no speed sensor data has been
detected at the Control Panel.
Not used
tion.
limits.
E
RROR AND
S C
ERVICE ODES