P2P Setting - Lorex D861 Series User Manual

15 Using the Main Menu
4. Configure the following:
If you want to use Lorex's email server (recommended):
• Mail Select: Select Lorex Mail.
• Receiver: Select up to 3 email addresses that will receive alerts. Enter each email address
into the field Email Address below.
• Subject: Enter a subject line for email alerts.
• Attachment: Enable (
NOTE
You must enable the Snapshot option for motion detection on each camera you would to receive attach-
ments. For details, see , page .
• Sending Interval: Enter the interval in minutes between email alerts.
• Health: Check to enable health check emails. Health check emails will be sent periodically
to ensure that the system is functioning normally.
• Sending Interval: Enter the interval in minutes for health check emails.
If you want to use your own email server (advanced):
• Mail Select: Select the mail server you want to use, or select Customize to use your own.
• SMTP Server: Enter the SMTP server address.
• Port: Enter the port used by the SMTP server.
• Username: Enter the SMTP user name.
• Password: Enter the SMTP password.
• Email Schedule: Click to setup a weekly schedule for email alerts.
• Receiver: Select up to 3 email addresses that will receive alerts. Enter each email address
into the field Email Address below.
• Sender: Enter the sender's email address.
• Subject: Enter a subject line for email alerts.
• Attachment: Enable (
NOTE
You must enable the Snapshot option for motion detection on each camera you would to receive attach-
ments. For details, see , page .
• Encrypt Type: Select SSL or TLS if your server uses encryption. Select None if your
server does not use encryption.
• Sending Interval: Enter the interval in minutes between email alerts.
• Health: Check to enable health check emails. Health check emails will be sent periodically
to ensure that the system is functioning normally.
• Sending Interval: Enter the interval in minutes for health check emails.
5. Click Test to send a test email to ensure settings are configured properly.
6. Click Apply.

15.7.4 P2P Setting

The P2P Setting menu is used only to enable / disable remote access to the system using a P2P
connection.
#LX400111; r. 5.0/56647/56647; en-US
) to include a image attachment of the camera.
) to include a image attachment of the camera.
70