Lorex D861 Series User Manual page 43

11 Motion Detection
7. Choose how the system will react when motion is detected:
• Show Message: Check to enable an on-screen pop-up when one of your cameras detects
motion. On-screen pop-up shows the channels an event occurred on and the type of event.
• Send Email: Check to enable email alerts. You must configure email alerts before you will
be able to receive them (see 15.7.3 Configuring Email Alerts, page 68).
• Record Channel: Select the channels that will record when motion is detected on the se-
lected channel. Set the length of recording following a video loss event in the Post_REC
field.
• PTZ Activation: Set connected PTZ cameras to start a tour, pattern, or go to a preset
location.
• Sequence: Sequence mode will begin. Select the numbered tiles next to this option to in-
clude the corresponding channels in the sequence.
• Snapshot: Select the numbered tiles next to this option to save a snapshot of the corre-
sponding channels.
• Buzzer: Check to enable the system buzzer.
8. Click Smart Motion Detection to enable Person and Vehicle detection:
NOTE
See 5 Camera Installation, page 11 for important camera installation notes related to channels with Person
and Vehicle detection enabled.
• Click Enable to activate Person and Vehicle detection on the selected channel.
• Select a Sensitivity level (a high sensitivity value will detect smaller objects than a low
value).
• Check Person or check Vehicle.
• Click OK when finished.
9. Click Apply.
10. (OPTIONAL) Click Copy to apply the settings for the current channel to one or more other
channels (see 15.12 Copying Settings to Another Channel, page 89 for full instructions on us-
ing the copy function).
#LX400111; r. 5.0/56647/56647; en-US 35