Troubleshoo Ng Procedures - Jacuzzi SWIMSPA Power Actve J16 Owner's Manual

15.0 Troubleshoo ng Procedures

In the unlikely event your swim spa is not working the way you believe it should, please first
review all the installa on and opera ng instruc ons in this manual and check the message on
the panel display second, if you are s ll not sa sfied it is working properly, please follow the
appropriate troubleshoo ng instruc ons:
PROBLEM
NONE OF THE
COMPONENTS
OPERATE (i.e
pump light)
PUMP DOES NOT
OPERATE
Pump Priming Instruc ons:
1. Turn off power to the swim spa.
2. Remove the handle from the massage selector supplied by the pump you are priming.
3. Loosen the massage selector's cap slightly (counterclockwise), listening for the air to
seep out.
4. Tighten the cap finger- ght, replace the handle and turn the swim spa's power back on.
Note: This method must be used for the jet's pumps because these pumps are not connected
to the main filter system in any way.
CAUTION:
to protect the system from freeze damage. See the sec on on Winterizing.
PROCEDURE
Check the control panel lights
1. If there are le ers or symbols displayed on the screen, refer to
the previous Sec on to determine the meaning and required
ac on.
2. If nothing appears on the screen:
A: Check the household circuit breaker
B: Contact your dealer or authorized service organiza on
Ac vate the "JETS"
1. If no sound is detected or if a "buzzing" sound is detected, turn
off power to the swim spa and contact your dealer or service
organiza on.
2. If the motor operates but no water flows to jets:
A. Pump may not be properly primed. See instruc on below.
B. Contact dealer or authorized service organiza on.
If freezing condi ons exist and pump is not opera onal, take measures
52