Jacuzzi SWIMSPA Power Actve J16 Owner's Manual page 6

In case of long periods of inac vity, it is advisable to fully drain the system. Periodic drainage,
during normal use, varies depending on the frequency of use, the contaminants and the type
of installa on. Even if not used par cularly frequently, you should change the water at least
once a month.
Prolonged sun exposure could damage the material of which the swim spa shell is made,
due to its capacity to absorb heat (dark colours in par cular). Do not leave the swim spa
exposed to the sun without adequate protec on when not in use (thermal cover, gaze
bo, etc.). Any damage resul ng from failure to observe these warnings are not covered
by the product warranty.
Live components and equipment (except those powered at very low voltage not exceed-
ing 12V) must be out of reach of individuals in the swim spa.
Jacuzzi® swim spas are class "1" appliances and must therefore be permanently connected,
without intermediate junc ons, to the electrical network and to the protec on circuit
(grounding system).
Parts containing electrical components, with the excep on of remote control devices,
must be posi oned or fixed so that they cannot fall into the swim spa.
The appliance must be powered by means of a differen al switch with opera ng current
which does not exceed 30mA.
The installer must use cables with a suitable cross-sec on with minimum characteris cs
equivalent to type H 05 VV-F. Please refer to the corresponding sec on.
For the equipoten al connec on of the appliance the installer must use the terminal provid-
ed and iden fied by the ground symbol. Please refer to the corresponding sec on. It is imper-
a ve to build a support base adequate to the load of the swim spa.
It is impera ve to provide a drainage system for accidental water spills. Please refer to the
corresponding sec on.
6