Light Cycle Op On - Jacuzzi SWIMSPA Power Actve J16 Owner's Manual

Purge Cycles
In order to maintain sanitary condi ons, as well as protect against freezing, secondary water
devices will purge water from their respec ve plumbing by running briefly at the beginning of
each filter cycle. (Some systems will run a certain number of purge cycles per day, independ-
ent of the number of filter cycles per day. In this case, the purge cycles may not coincide with
the start of the filter cycle).
If the Filter Cycle 1 dura on is set for 24 hours, enabling Filter Cycle 2 will ini ate a purge
when Filter Cycle 2 is programmed to begin.

10.8 Light Cycle Op on

If the Light Cycle does not appear on the Se ngs Screen, the Light Timer feature is not ena-
bled. The Light Cycle Icon on the Se ngs Screen takes you to a screen where you control the
Light Cycle. When available, the Light Timer is ('Disabled") by default. Press "Disabled" to
change it to "Enabled" (ON). The se ngs can be edited the same way that the Filter Cycles
are edited.
Brightness Up Bu on: Tap to raise the intensity of the lights to the maximum level of 5. The intensi-
ty levels are as follows: 5 = 100%, 4 = 80%, 3 = 60%, 2 = 40%, 1 = 20% and 0 = 0%.
Brightness Down Bu on: Tap to lower the intensity of the lights to the minimum level of 0.
Intensity Indicator: Displays the current intensity level of the lights by the number of bars filled in.
this will only work with the solid color op on. If the blending mode is on, the light bulb is grayed out.
The range is from 0 to 5.
Speed Control Bu on (Increase): Tap to increase the blending speed of the colors to the maximum
speed of 5. The speed se ngs are as follows: 5 = every 5 secs, 4 = every 10 secs, 3 = every 15 secs, 2 =
every 30 secs and 1 = every 60 secs.
Speed Control Bu on (Decrease): Tap to decrease the blending speed of the colors to the minimum
speed of 0.
Color Selector: Tap a color to select a single color.
Back Bu on: Tap to go back to the previous menu.
Invert Bu on: Tap to invert the display image.
38