Haier MRV 5-RC VP1-112B Service Manual page 76

Install snow cover
Snowfall area, please install snow cover, see the right
picture,To be unaffected by the snow, it is important to set
up a high platform, which is calculated according to the
maximum amount of snow in the area. At the same time, the
outdoor external machine defrost setting change to be easy
to frost setting, detailed see the digital tube setting.
Panel disassembly instruction
Please refer to the following figure for the repair board to remove.
1. Remove the screw with a screwdriver and remove the repair wrench from the bottom of the machine (or use a
self-prepared screwdriver).
Screw
Maintenance
wrench
2. Remove the screw A, B, and C by rotating the wrench in the
direction of the arrow.
A
B
C
Outlet snow cover
3. Along the direction of the arrow, after
repair plate rotating about 40 °, the
plate on the right side of card claw, can
complete repair plate disassembly.
73
Inlet snow cover